⏱ 2 min read

LED UV lamp: curing times and good habits

Which lamp to choose, how long for each layer, why gel heats up, and how to avoid under-cured gel.

LED UV lamp: curing times and good habits

The essentials in 30 seconds

  • Gel doesn't air-dry: it hardens under the light of a lamp.
  • Today you use an LED UV lamp: LEDs that give off the UV light the gel needs.
  • It is fast (30 seconds per coat, 60 seconds for the final top coat), energy-efficient and lasts a very long time.
  • These are averages: always follow the manufacturer's instructions.
Contents
  1. Which lamp?
  2. Indicative times
  3. Why does it get hot?
  4. Placing your hand properly
  5. Signs of under-cured gel
  6. Safety

Gel doesn't air-dry: it hardens under the light of a lamp. We say it “cures” (or “polymerizes”). An under-cured layer stays soft underneath, lifts and can irritate the skin. The lamp matters as much as the products.

Which lamp?

Today you use an LED UV lamp: LEDs that give off the UV light the gel needs. It is fast (30 seconds per coat, 60 seconds for the final top coat), energy-efficient and lasts a very long time. The old UV tube lamps, much slower, have almost disappeared.

Choose a model of at least 36 W and check on your gel packaging that it is compatible.

Indicative times

Layer Cure
Base coat 30 s
Builder gel 30 s
Base color (each coat) 30 s
Magnetic gel 30 s, right after the magnet
Jelly, glitter 30 s
Top coat 60 s
Chrome powder No lamp for the powder

These are averages: always follow the manufacturer's instructions. A low-power lamp (under 36 W) often needs longer.

Why does it get hot?

A feeling of heat, or even burning, can occur under the lamp, especially with thick gel (builder) or a very powerful lamp. It's the curing reaction releasing heat. If it's uncomfortable, take your hand out for a few seconds, then put it back. Thinner coats reduce the effect.

Placing your hand properly

  • Fingers flat, in the center of the lamp.
  • Cure the thumb separately: in most lamps it sits at an angle to the other fingers and doesn't get enough light.
  • Avoid shadow zones (edges of the lamp) for the little fingers' nails.

Signs of under-cured gel

  • soft surface, or gel that dents under a fingernail;
  • gel that wrinkles or puckers;
  • a strong smell that lingers;
  • quick lifting.

If so, extend the curing time, apply thinner coats, or check your lamp's power and condition.

Safety

The skin around the nail also receives UV light. To limit exposure, you can apply sunscreen to your hands fifteen minutes before, or wear UV-protective gloves that leave the nails free. Never get gel on the skin: as it hardens it can cause an allergy.

In the 3D studio, each layer's curing time is shown when you tap its bubble in the strip.

LED UV lamp: curing times and good habits

Try it in the 3D studio

← All guides